Fairly new here. I'm a big fan of spreadsheets and looking to keep track of BD quality along the different stages. Then I can figure out if any changes I make actually do anything haha.
Just wondering what you experienced brewers consider important to record?
So far these are the standard tests that I do.
1. 3/27 test
4. Moisture Content (ppm)
5. Soap Content (ppm)
7. Flash Point
Are there any other useful tests that I should be using?
Welcome to the forum!
In my mind, the only test that is important is the "bright and clear" test and that is the only test I use for my biodiesel.
Biodiesel is an oil and oil does not have pH so your pH test will tell you nothing important.
Assuming you are using WVO from fryers to make your biodiesel, if you pass the 3/27, soap and moisture test then you will also pass the Density, and Viscosity test so you do not need to do those two.
For our situation I see no value in the flash test.
Wow, thanks for the prompt reply! Great to know your points, sounds much more simple than I thought haha
The following tests are run on each batch of BioDiesel:
1. estimate of conversion percent w/ dropout from 10ml BD + 90ml methanol
2. estimate of residual soap/glycerol w/ 1/3 dist water 2/3 washed & dried BD
3. estimate of water content in BD and fuel blends w/ carbide & manometer
Cold climate operations require more quality control of fuel to eliminate contamination from soap/glycerol and water. Also, computerized fuel systems require high quality BD fuels as compared with mechanically controlled fuel systems.
You have piqued my interest!
I do not believe I have ever run across this test where you estimate the Residual soap/glycerol w 1/3 dist water and 2/3 washed and dried BD.
Please provide a link or give a detailed description how this test is performed and how you read the results
a new member interested in testing, thats good.
You would be better using the 10/90 tube for the dropout/conversion. Far more accurate than doing a 3/27. Also the proper 10/90 tubes are calibrated down to 0.05mls on the low end.
How are you testing for water.
So I take it you are no longer using the 30/270 test rig that you were using last year.
This is the first time I have heard about a "proper 10/90 tube"
I am curious who made the determination that it was the proper 10/90 tube.
It would be good if you could provide a link to these proper 10/90 tubes you are recommending.
I designed and had a proper 10/90 test tube made for me, custom made. It is shaped like a separatory funnel but is closed on the lower end. It has a pear shaped upper reservoir with a lower calibrated tube with 0.05 milliliter divisions. The upper pear shaped reservoir is calibrated also. 1,2,3,4,5 milliliters, 10,15,20,25 ml then 30,40,45,50 ml then 60,70,80,90,100ml. It might be a unique piece of chemistry equipment. NDS Technologies, Inc. 891 East Oak Road, Vineland, New Jersey 08360, telephone in USA (800)367-0330, made two of these tubes for me. Ordering information for one of these tubes is Item#8005-02, previous price quote was $590.00/ 6 pieces. The cost might have gone up since July 17, 2014 when the price quote was made. Norm Neill was the contact person if you want to order two or more of them. They are a custom job, not off the shelf.This message has been edited. Last edited by: WesleyB,
|Powered by Social Strata|