i water wash my bio 800lt at a time and use a compressor and airstone to bubble. after my final wash whats the quickest way to dry my bio (currently i continue to bubble the bio but eish it takes way too long to dry) any better solution
Originally posted by andyman: heat. lots of it. bubble at 60*C for four hours. dessicant is required if environmental humidity is high. a carbide manometer is highly recommended.
Heat, but NOT "lots of it". Gentle heat, 100-120°F max. Don't promote oxidation of the BD, only a small amount of heat is needed to make the water evaporate out better. Bubble dry air from a compressor through a desiccant into the bottom of the heated tank. Blow or suck warm room air across the top of the tank and vent outside. This 'tank air' will contain methanol vapors, so vent accordingly away from sparks, flames or people. A 250 gallon fuel oil tank makes a good drying tank; a 100CFM 'bathroom fan' with a brush-less induction motor works for an extraction fan.
Location: coldest N.America | Registered: May 03, 2005